|
|
You can see all contents of the 'DF-02 Aluminum-damper set' with pics . From the left... Two short-parts for rear dampers (X parts for CVA short) Four short-parts (V parts for famous low friction dampers ) Fine-finished Shock-bodies and yellow springs( Rate is same as standard). Large bag includes aluminum pillow-balls, piston-rod and Teflon pistons (each four 2 hole and 3 hole), and snap rings - Small bag includes red silicone O rings, Diaphragms (the same as that of a TRF's), Aluminum spring guides. This damper is longer than stock CVA. (Front +1mm and Rear +5mm) Aluminum damper which equipped the high quality piston gives good effectiveness. Its standard-setting (2 holes piston and no. 400 oil) is stiff than No. 800 oil and standard 1 hole piston of standard CVA damper. There is superb value for money in this Item and it's not so expensive. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
"DF-02 Aluminum damper
|
front |
rear |
etc. |
|
| Piston |
2holes with 0.1mm shim |
3holes with 0.1mm shim |
Shims not included |
| Oil |
no.300 (OP.443 Orange) |
no.400 (OP.444 Yellow) |
Tamiya Hop-up options |
| Spring |
Yellow |
Blue (OP.702) | |
| Inner spacer | None | None |
|
| Spring Initial |
1.0mm |
6.0mm |
|
| Bottom stopper | None | 5 red O-rings and 2 black O-rings | Tamiya spare parts |
| Lower set Pos. |
In |
Out | |
|
Put "Pressure-sponge" in all diaphragm-chambers, like the TRF low friction dampers. |
|||
